Patented air/water separation system which does not draw air from the surrounding environment.
- Reduction of the noise level produced by air entering from outside.
- Particles in suspension in the air are not drawn into the vacuum pump, avoiding damage to the blades, bearings, casing and cover.
- The vacuum pump is always ready to operate at its maximum level whenever there is air in the suction line.
- Robust construction: cast iron separator and stainless steel float mechanism.
- Vibrations and strains on the unit and its motor or engine are reduced to a minimum.
- There is no need for suction filter in the vacuum pump, further reducing the maintenance operations
- Separation system leaves the impeller inspection cover free
When pumping liquids with solids in suspension, it is possible to inspect and, if necessary, unclog the impeller without removing the hoses or the separator.
|
|
Float mechanism without adjustment
- No need for periodic checks
- During maintanence, there are no adjustments to carry out.
|
|
Rotary claw vacuum pump without lubrication
- No contact between the moowing parts: long operation life for the vacuum pump on site
- Unit does not emit oil in to the air
- No risk of loss of oil from the vacuum pump or its lubrication circuit.
- No need to check the levels of oil and/or condensate daily
|
|
Diesel driven units:
- Fuel tank with capacity for more than 24 hours of operation
- Hand pump for draining the engine oil sump mounted as standard equipment
|
|
Electricaly driven units:
- Control panel automatic start/ delta starter as standart equipment
- Starting current and mechanical strains are reduced
- Avoids overloading generating sets on site when pumps are started
- Does not require intervention by specialised personnell.
- Includes provision for automatic start/ stop with float switches
|
|